ISSN 1991-2927
 

ACP № 1 (59) 2020

The Development and Analysis Method and the Model of Computer Simalator

Aleksandr Nikolaevich Afanasev, Ulyanovsk State Technical University, Doctor of Engineering, Professor; graduated from the Radioengineering Faculty at Ulyanovsk Polytechnic Institute; Vice-Rector for Distance and Extended Education at Ulyanovsk State Technical University; an author of more than 200 articles in the field of CAD, interested in automated training systems, computational process and computer structure organization, intelligent system design, CAD, composite workflow control, graphic language diagrammatics [e-mail: This email address is being protected from spambots. You need JavaScript enabled to view it. ]A. Afanasev,

Nikolai Nikolaevich Voit, Ulyanovsk State Technical University, Candidate of Engineering, Associate Professor at the Department of Computer Science at Ulyanovsk State Technical University; graduated from the Faculty of Information Systems and Technologies at Ulyanovsk State Technical University; an author of more than 114 articles in the field of intelligent CAD systems, CASE and CALS technologies; interested in intelligent development systems of complex computer-aided systems, automated training systems, graphical languages and grammatics. [e-mail: This email address is being protected from spambots. You need JavaScript enabled to view it. ]N. Voit,

Dmitrii Sergeevich Kanev, Ulyanovsk State Technical University, Post-graduate Student at the Department of Computer Science at Ulyanovsk State Technical University; graduated from the Faculty of Information Systems and Technologies of Ulyanovsk State Technical University; an author of more than 20 articles in the field of CAD; interested in development and distribution of firmware systems intended for maintenance, intensification, and increase of trainee involvement in educational process with the use of information technologies. [e-mail: This email address is being protected from spambots. You need JavaScript enabled to view it. ]D. Kanev

The Development and Analysis Method and the Model of Computer Simalator 000_7.pdf

An intensive usage of high-technology equipment for present-day developed production process makes high requirements on personnel training. Therefore, the adoption of modern information technologies particularly simulators for the educational process is an urgent problem of the great practical importance. The existing approaches to the implementation of virtual simulators and trainee actions assessment methods are analyzed, also their advantages and disadvantages are determined in the article. The author’s virtual simulator model intended for web-oriented realization and the method of trainee actions analysis for his competence assessment. Due to this approach, specialist training process could be able without coachers because the system controls trainee actions by checking learning tasks. Represented solutions allow to develop high-performance simulators and to use them in organizing personnel trainings that meet modern production requirements. Particularly, the model was tested and used for the development of the following device simulators: C1-116, C1-127, and C1-125 oscillographs, CNT-90 timer/counter/ analyzer, and RG4-17-01A high-frequency signal generator.

Virtual simulator, automata approach, simulator realization, trainee action assessment.

© FRPC JSC 'RPA 'Mars', 2009-2018 The web-site runs on Joomla!